Repair index / GR I + GR II

Eight areas.
One specialist.

International mail-in

Every camera is inspected before work begins. The repair route and quote are based on the actual fault found, not the symptom alone.

01

Lens errors, intermittent extension and confirmed cable damage.

Lens flex cable

Diagnosis and replacement work inside the retracting lens assembly, to repair the common flex cable issue and modifying the housing to relieve strain on the new cable.

View repair & pricing ↗
Ricoh GR lens mechanism with orange flex cable
Original GR I reference component photographed during disassembly.
02

Pop-up flash bulb and associated assembly faults.

Flash bulb

Inspection of the flash bulb, pop-up assembly and its visible wiring before a repair or replacement route is recommended.

View repair & pricing ↗
Open Ricoh GR chassis showing its flash
Original GR I reference component photographed during disassembly.
03

Board-level diagnosis including no-power faults.

Mainboard / motherboard

Component-level fault finding on the original GR mainboard. Electronic repairs are assessed individually and only begun after approval.

View repair & pricing ↗
Component side of a Ricoh GR mainboard
Original GR I reference component photographed during disassembly.
04

Display faults and damaged LCD modules.

LCD repair / replacement

The internal LCD module is inspected separately from the protective outer window, then repaired or replaced where a compatible part is available.

View repair & pricing ↗
Removed Ricoh GR LCD module
Original GR I reference component photographed during disassembly.
05

Worn, lifting or damaged exterior grip material.

Rubber grip replacement

Exterior grip work focused on restoring a secure, clean handling surface while preserving the original shell beneath it.

View repair & pricing ↗
Ricoh GR rear shell and textured grip
Original GR I reference component photographed during disassembly.
06

Unresponsive, inconsistent or damaged rear controls.

Button membrane / snap dome

Diagnosis of the rear control contacts, button membrane and snap-dome interface rather than replacing unrelated assemblies.

View repair & pricing ↗
Ricoh GR rear controls beside snap-dome contact board
Original GR I reference component photographed during disassembly.
07

Scratched, cracked or damaged protective display window.

Outer LCD window

Replacement of the protective outer LCD window as a distinct service from replacement of the working LCD module behind it.

View repair & pricing ↗
Ricoh GR rear shell and outer LCD window opening
Original GR I reference component photographed during disassembly.
08

Internal cleaning after visible dust is confirmed.

Sensor cleaning

Careful access to and cleaning of the original sensor assembly, followed by an image check before the camera is returned.

View repair & pricing ↗
Removed Ricoh GR image sensor assembly
Original GR I reference component photographed during disassembly.

Not sure what to buy?

Start with
the symptoms.

Use the fault guidance form ↗